Speed Controller for Linear Actuators

      Speed Controller for Linear Actuators

      Model #
      qty limit cart limit

       The Firgelli Automations Speed Controller allows you to control the speed of our 12V DC actuators up to a maximum current rating of 6A and all our gear motor products.

      Designed using a motor controller and high frequency Pulse Width Modulation (PWM) you are able to control the speed of your Actuator/Motor with minimal impact on the force output. 

      You can reduce the speed to just under 50% with little loss of force. Force loss is determined by inertia of the actuator and could be more with higher force actuators.

       It will allow you to slow the actuator down, but not increase the speed beyond the speed at which it runs with no controller.

      The FA-SC1 is intended to control the speed of one linear actuator. DO NOT connect two actuators to the same FA-SC1. The maximum current capability of the unit is 10A; even two small actuators connected together to the Speed Controller could draw a startup surge current exceeding 10A which will damage the unit.

      Please note if you adjust the speed it will also change the speed when you reverse the actuator. If you want to change the speed in both directions then you need to use the FA-SC2 

      Includes black case

      Model # FA-SC1
      Output Current 0 to 6A
      Input Voltage 12-16V DC
      No Load Output Current <50mA
      Output Voltage 12V
      PWM Signal 10KHz
      Stand-by Current in Armed State Lower 15.7mA
      Dimensions L: 3.3” x W: 2.88” H: x 1.18”
      Speed Range 33% to 100%
      Operating Temp. -40° C to +40° C

      Click here to view user manual 

      Wiring Diagram